Piper Archer III Performance Pad [iPad]

Gyronimo Performance Pad Piper PA 28-181 -Archer III-
The ultimate computer for Mass & Balance and Performance.

**** NEW: FLAPS UP takeoff distance computation ****

Calculate and interpolate performance data using the actual values
from the Archer III Pilot's Operating Handbook (POH).

Finish your complete fight planning in just a few seconds.
Performance planning has never been easier and quicker.

Results are updated immediately and displayed in high resolution graphics,
enhanced for the iPad Retina.

Change all important values using sliders.
Experiment with the results and create "what if" scenarios in no time.

Find your optimal cruise altitude, takeoff ground roll, landing distance,
climb data and stall speeds.

The Performance Pad Archer III has seven main pages:

1. The Mass & Balance (or Weight & Balance) Page
Calculates Center of Gravity, Moments, Takeoff and Zero Fuel Mass as well as Percent MAC (% MAC).

2. The Takeoff Page
Using the actual data from the Operating Handbook
the Performance Pad calculates and displays Ground Roll and Landing Distance
based on:

- Aircraft Mass
- Takeoff Elevation in MSL (Pressure Altitude and Density Altitude will be computed)
- Outside Air Temperature (OAT)
- Altimeter Setting
- Runway Conditions (i.e. paved dry to long grass or snow)
- Runway Slope
- Wind Conditions

3. The Climb page
Calculates time, fuel and distance based on
- Difference between Takeoff Elevation and intended Flight Level
- Altimeter Setting
- Outside Air Temperature (OAT)
- Altimeter Setting
- Headwind or Tailwind Component

Also the Rate of Climb and Climb Speed will be displayed.

4. The Cruise Page
Using the actual data from the Pilot's Operating Handbook you can
determine the optimal cruise altitude based on
- Trip Distance
- Flight Level
- Engine RPM
- Temperature
- Wind and Altimeter Setting

5. Landing Page
Calculates Ground Roll and Landing Distance based on wind, elevation, altimeter setting etc.
Like on the Takeoff Page you can use the Wind Components Computer to quickly determine head- or tailwind components

6. Stall Speed Page.
Calculates The Stall Speed based on Bank Angle and Flap Settings.
Stall Speed will be computed as KIAS and KCAS using the actual values from the POH.

7. Setup
- Load and Save up to five Aircraft Settings and Scenarios.
- Send a Mass & Balance Summary to your email address.
- Visit our video channel and watch tutorials and video manuals.

Mode Switch:

The Performance Pad can be used in two Modes:

"Individual Mode"
All calculations can be done independently from each other.

"Plan Mode"
Calculated values will be forwarded to the next page and an additional "Flight Summary Page" is
available. Choose this mode if you want to do a complete performance planning.

The author disclaims any liability for any direct, indirect, incidental, or consequential losses or damages in connection with your access to or use of this software. The information contained in this software is for general information purposes only.